led corn bulbs installation

led corn bulbs installation

In modern times, the circuit equipment has formed a network, and most of them are satisfied with the output and layout of the existing lamps. But the traditional lamps and lanterns used are aging, and the energy consumption is large, not green. So refitting is more cost-effective than completely redesigning (including replacing lamps, bulbs, and ballasts). LED are green energy, energy saving, environmental protection, Long lifespan, and good heat dissipation. Many customers who choose to use LED retrofit kits achieve 50-75% cost savings over the redesign. And one of the biggest advantages of LED lights is the long service life-up to 50000-100000 hours.

 

Compared with the traditional light source, led corn bulbs has better environmental protection benefits. There is no UV or IR in the LED spectrum. The waste can be recycled without pollution and mercury. led corn bulbs can be safely touched. This is a typical green light source. led corn bulbs do not use high-risk mercury fluorescent lamps, nor do they have mercury ions, phosphorus, and other harmful substances.LED is a more advanced cold light source, cold light source is almost no infrared spectrum light source, when objects emit light, its temperature is not higher than the ambient temperature. It will not make the bulb yellow, will not accelerate the aging of lamps, and will not constitute a greenhouse effect on the surrounding environment.

 led corn bulbs

Led refit kits are also less destructive to refitting. An led corn bulbs is usually just an integrated LED lamp, which is lighter, thinner, and more integrated. Most refitting kits can be installed and used while the original fixture remains in place. Installation is also very simple and convenient but one needs to pay attention to Switch off the power supply before installation and let the electrician or the person who has the same ability install the lamp. The led corn bulbs Must be connected via the Driver supplied. Connecting directly will destroy the kit.

Step 1: Remove the reflector and all other existing components except the socket(E26/E39) from the fixture.

Step 2: Fix the retrofit into position in the fixture by E26/E39 socket. Fix the driver with the existing screw holes of the reflector.

Step 3: Connect the driver's DC output wires to the retrofit kit by the supplied connectors.

Step 4: Connect the driver's Positive(L), negative(N), and ground(G) to the existing wiring to the fixture using the snap-action connectors.

Please noted that The E26/E39 socket on the “Y” bracket is only for fix the retrofit kit, with no power connection on it. Secure any loose wires with zip ties to prevent them from interacting with the cooling fan. The luminaire should be marked "This luminaire has been modified and can no longer operate the originally intended lamp”.

Attention: Use wire nuts to connect the Driver DC output and the LED input connections ensuring correct polarity.

» Please always use the light out of its package. Before starting the use of the light, please check if the light was damaged during transportation. If any damage was shown, please do not install or use it.

» Any maintenance should be performed by trained professionals only.

» Keep packaging materials away from the reach of children and pets. Risks of suffocation!

» Caution! The packaging contains small parts that may be swallowed by children.

» Never leave children unattended in the vicinity of the lights and do not allow them to play with electrical devices.

» Try to avoid looking directly in the LED beam-especially for extended periods of time.

» Do not shine the LED light in another person’s eyes.

» Never cover the light by other objects.

» The products need to re-repair, inspection or special treatment of retirement after service time.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.